Animal Repeller

Thank you for choosing this animal propeller. Please read and understand these instructions and keep this manual for future reference. This repeller is designed for permanent service allowing you to install it once and let it work! It is weather-proof allowing it to work all year-round and in virtually all weather conditions. It uses solar power to recharge the batteries so it's always working. The Passive Infrafed sensor (PIR) detects motion and triggers the ultrasonic speaker emitting a tone that people cannot hear but chase away common outdoor pests like dogs, cats, deer, raccoons, mice, skunks, squirrels and more. This solar animal repel ler is a safe and humane way to keep unwanted animals away!

WARNING! Always check for underground utilities, cables or, wires before digging or Installing! Failure to check could result in personal Injury, property damage or even death.

To Assemble and Install:

1. Unpack the unit completely and confirm that all parts are present. SEE FIGURES 1-3 above.

2. Connect the repel ler head, pole sections, connecting part and ground stake. SEE FIGURES 1-3 above.

3. Turn power switch to "ON" position. SEE FIGURE 2.

4. The PIR repeifer is designed to be left ON continuously. It uses four 2/3 AA size NI-MH rechargeable batteries

5. Once turned ON, the Red-LED light and ultrasonic signal will activate for 15 seconds. Among the time there is sound waves for 2.5 seconds at the begining. Following this activation. The unit will move to stand-by mode.

6. The unit is now ready for installation. The location should allow adequate sunlight to keep the batteries fully charged. Be sure that the area where needing protection is within the effective range of the repeller SEE FIGURE 2.

7. For best results, keep the repeller head roughly 9-10 inches above groud.

8.Take care not to stress or break the repeller when installing on hard ground. It is a good idea to prepare the ground for the ground stake to avoid damage to the unit.

9. When the PIR sensor detects motion, Red-LED light will be lit uph. Following this,the repeller will return to stand-by mode

10. When the device is working and the PIR sensor detects motion, the device will run for other 15 seconds in the next time.

Specifications:
1. Unit Dimensions: 5-1/2" Wx 3-1/2" D x 14-1/3" H.
2. Unit Weight: 8-1/2 Ounces.
3. Power Supply: 4 x 2/3AA Ni-MH rechargeable batteries.
4. Power Consumption: working=100mA standby ≤ 10uA
5. Ultrasonic Frequency: 25-61 KHz
6. Coverage Area: 30 feet @ 1100=2,4-25 square feet

CAUTION:
• Allow the Animal Repeller to operate continuously for best results,
• Do not immerse repeller in water.
• Do not cover-up the PIR sensor.
• To clean the repeller, use a damp-soft cloth and mild soap with water. Do not use harsh chemicals or abrasive cleaning agents that may damage the repeller.
• pls charge 2-3 hours under sunttght before first use.